Table of Contents
Advertisement
Connecting the connection cord
the electric connections.
The indoor unit is powered by the outdoor unit by means of a H07 RN-F connection cable (or a more power model),
with insulation in synthetic rubber and jacket in polychloroprene(neoprene), in accordance with the requirements of standard EN 60335-2-40.
1. Remove the screw on the electrical component box and remove the cover plate.
2. Route the connection cord through the side of the indoor unit and connect the cable to terminals; refer to the figure below.
3. Route the other end of the cable to the outdoor unit through the ceiling & the hole on the wall.
4. Reassemble the electrical component box cover, carefully tightening the screw.
Wiring diagram
1 phase
1(L)
2(N)
1(L) 2(N)
L
N
Cable tie
Indoor Power
Main power cable
Cable clamp
Between Indoor and Outdoor Connection cable Specifications(Common in use)
Indoor Power supply
Power Supply
Power supply cords of parts of appliances for outdoor use shall not be lighter than polychloroprene sheathed flexible cord. (Code designation
Terminal Block SPEC (Indoor)
11
13
F2
F1
Communication cable
Communication Cable
Indoor Power cable
double shielded(Tape aluminum / polyester braid + copper)
cable of FROHH2R type.
9.0
3 phase
1(L)
2(N)
1(L) 2(N)
L1(R)
L2(S)
Indoor Power
power cable
M3.5
M4
12.0~18.0
·m = 10 kgf·cm
F2
F1
L3(T)
N
F1
F2
Cable tie
Cable clamp
Communication cable
8.0~12.0
15
Advertisement
Table of Contents
