RUSTA 629601520101 Manual page 8

ENG
CLEANING
Clean the circular mesh regularly. How to remove the circular mesh: Switch off the
power and allow the unit to cool. Remove the collector.
A. Push up the rear of the circular mesh's lower ring
into the unit's casing until the two front catches on
the frontof the circular mesh are released (image A).
B. Pull the circular mesh downwards and forwards
so that the circular mesh's upper ring loosens and
pull the mesh out of the unit (image B). Remove
any insect remains from the mesh that surrounds
the circular mesh. Wash the mesh with water and
shake off any excess water before replacing it.
C. Replace the circular mesh by holding it at a slight
angle. The two front catches must be on the outside.
Insert the front of the upper funnel ring inside the
unit's casing (image C).
D. Push the circular mesh up and with the back part
of the lower funnel ring at a slight angle. Press the
circular mesh together until the front catches on
the circular mesh's lower ring are inside the casing
(image D). Release the circular mesh so that it ends
up in place.
PLEASE NOTE! The upper part of the circular mesh
must be positioned directly under the fan. Replace
the collector. Reconnect the power and restart the
unit.
ACCESSORIES
Octenol mosquito attractant:
MA-1000 makes your
more effective and attracts mosquitoes
and gnats!
8
mosquito trap
A
Lower ring
of circular
mesh
Push up here
B
Forwards
Upper ring
of circular
mesh
C
Front edge of
upper ring of
circular
D
Casing
Up
Front
catch
Down
Catch
Up
Up