Fitting The Harness - Stihl FS 110 Instruction Manual

English / USA
Closing the cap
: Fit the cap – grip upright –marks
must line up.
: Turn the cap clockwise as far as
stop (approx. a quarter turn).
: Fold the grip flush with the top of the
cap.
: If the grip does not lie completely
flush with the cap and the detent on
the grip does not engage the recess
in the filler neck, the cap is not
properly seated and tightened and
you must repeat the above steps.
32

Fitting the Harness

Shoulder strap*
: Put on the shoulder strap (1).
: Adjust the length of the strap so that
the spring hook (2) is about 2" below
your right hip.
: Balance the brushcutter.
The use of the harness is described in
chapter "Approved Combinations of
Cutting Tool, Deflector, Handle and
Harness".
* see "Guide to Using this Manual"
Full harness*
: Put on the full harness (1).
: Adjust length until the spring hook
(2) is about a hand's width below
your right hip.
: Balance the brushcutter.
The use of the harness is described in
chapter "Approved Combinations of
Cutting Tool, Deflector, Handle and
Harness".
* see "Guide to Using this Manual"
FS 110, FS 110 R