Stihl FS 110 Instruction Manual page 22

7
7
Mounting the Handlebar
: Place the handlebar (7) in the lower
clamp (1) so that distance A is no
more than 6 in (15 cm).
: Place the upper clamp in position
and hold both clamps together.
: Push the wing screw, with washer,
through the two clamps as far as
stop – hold all parts together and
secure them.
FS 110, FS 110 R
A
1
A
1
: Place the secured assembly on the
handle support (8) with the wing
screw at the engine side.
: Push the wing screw into the handle
support as far as stop and then
screw it down – but do not finally
tighten yet.
: Line up the handlebar at a right
angle to the drive tube – check
dimension A again.
: Tighten down the wing screw firmly.
8
English / USA
13
12
9
11
10
Mounting the Control Handle
: Loosen the screw (9) and remove it
with the washer (10) (if fitted). The
nut (11) remains in the control
handle (12).
: Push the control handle – throttle
trigger (13) must point toward the
gearbox – onto the handlebar (7) so
that the holes (14) line up.
: Insert screw with washer (if fitted)
and tighten down firmly.
12
7
14
21