Advertisement
12. Perform a Scanner Light Level adjustment:
12.1 Extend the Scanner Original Support Guides
12.2 Perform the Light Level adjustment by inserting the Calibration and Stitch Target, black section inserted first; face up, so
the Target is taken instantly. If the sheet is not straight, lower the scanner's platen and remove the Target, then close
the platen. The scanner will cycle; then insert the Target again.
12.3 Use the following Keypad button sequence to execute the Light Level adjustment:
Important:
Press these 2 buttons
together to access the
Engineering Menu
Page 6 of 14
Advertisement
