Guide to the Manuals Open the Package Quick Start Guide (this guide) This guide describes a series of processes, from opening the package to using the scanner. READ THIS GUIDE FIRST! Scanning Guide (HTML format manual) Refer to this guide when you have finished setting up the scanner according to the procedures in the Quick Start Guide.
Check the Package Contents Scanner and Accessories Stand Page 11 Scanner USB Interface Cable Documents and Software Programs • Quick Start Guide (this guide) • Additional documents • CanoScan Setup Utility CD-ROM ScanGear CS (25 MB / 5 MB) - Scanner Driver It allows you to scan and load images from the scanner.
Install the Software (Windows) • With Windows XP/2000, you should log on with an administrator user name when you install or uninstall software programs. 1 1 1 1 Turn the computer on. If the "Found New Hardware Wizard" or "Add New Hardware Wizard" appears, click [Cancel]. 2 2 2 2 Place the CanoScan Setup Utility CD-ROM in the drive.
Install the Software (Macintosh) 1 1 1 1 Turn the computer on. If the “...Would you like to look for the software on the Internet?” appears, click [Cancel]. 2 2 2 2 Place the CanoScan Setup Utility CD-ROM in the drive.
Unlock the Scanning Unit • Unlock the Scanning Unit before connecting the scanner to the computer. If it is left locked, a malfunction or other problem may occur. 1 1 1 1 Peel the caution seal on the front of the scanner. 2 2 2 2 Gently turn the scanner over.
Connect the Scanner • Confirm that the Scanning Unit is unlocked. (P.5) 1 1 1 1 Peel the caution seal on the back of the scanner. 2 2 2 2 Connect the scanner to the computer with the supplied USB interface cable. Windows USB Interface Cable Small Square...
Try Scanning The following steps explain how to scan with ArcSoft PhotoStudio. 1 1 1 1 Place a photo or a picture on the glass by aligning its top edge with the alignment mark, and close the document cover. Bottom Alignment Mark Windows Macintosh...
Try Scanning Windows Macintosh 4 4 4 4 4 4 4 4 Click the Acquire icon or click the Click the Acquire icon or click the [File] menu and select [Acquire]. [File] menu and select [Import...]. ScanGear CS will start. ScanGear CS will start.
Try Scanning 7 7 7 7 Click [Scan]. The final scan will start. 8 8 8 8 Click (close box) in the ScanGear CS window to close it. The scanned image will appear in the PhotoStudio window. 9 9 9 9 Save the scanned image.