Lakeshore 4-Way Sand & Water Table Quick Start Manual

Sand & Water Table
This cleverly designed table lets 4 children explore the properties of
sand and water at the same time! The textured tubs lift out easily for
cleaning and changing materials, and adjustable legs allow you to
choose the right height for your students.
To assemble the table, simply follow the instructions in this guide.
We've supplied the hardware, so all you need is a Phillips screwdriver
and pliers or an adjustable wrench.
Before You Begin
Separate and identify the following components:
• 1 double-center brace
• 2 end braces
• 8 connector braces
• 8 long bolts and locking nuts
1. Use 8 long bolts and nuts to attach the connector braces to the
double-center brace, as shown. Note that the hole positions on
one side of each connector
brace are closer to the end
of the brace. Make sure
that this side goes next to
the center brace for all 8
connector braces. (If the
connector braces have been
assembled properly, the tops
of all the braces will be level.)
Connect the nuts and bolts
loosely. (You will tighten them
after all the hardware is in place.)
© Lakeshore 2003
(800) 428-4414
www.lakeshorelearning.com
4-Way
• 16 short bolts and locking nuts
• 16 washers
• 4 plastic tubs
Note: Attach the locking nuts with the plastic
side facing out, as shown at left.
holes closer
to ends
(continued on back)
TT678
Ages 3+