Setting Up Your Vtech 900I - VTech 900I Instruction Manual

Setting Up Your VTech 900i
1. Choose an area near an electrical
outlet and a telephone wall jack.
AC TELEPHONE
ELECTRICAL WALL
OUTLET JACK
2. Install optional 9V back-up battery
in compartment located on
underside of 900i base unit. This
battery retains memory in the event
of a power outage. VTech
recommends the use of an alkaline
4. Plug the AC power adapter into an
electrical outlet. The ONlOFF LED
will flash during initialization for
about 20 seconds. After initialization
of the ITAD, the LCD clock display
will flash until it is set.
NOTE: Connect power to the base unit
before placing the handset in the cradle.
4.
Set the TONUPULSE switch on
the base unit. If you have touch
tone service on your phone line, set
the switch to TONE. If you have
rotary service, set the switch to
PULSE.
I
battery.
5. Fill in the telephone number card
3.
Connect the telephone line cord.
Insert one end of the telephone line
cord into the jack at the rear of the
base unit. Plug the other end into a
telephone wall jack. Make sure the
plugs snap securely into place.
6.
CHARGE THE HANDSET CAUTION:
BATTERIES BEFORE USE.
1. Never install telephone wiring during
The batteries recharge a lightning storm.
automatically wheneverthe handset
is in the base unit cradle. The 2. Never install telephone jacks in wet
batteries must be charged for 24 locations unless the jack is
hours before using your phone for
specifically designed for wet
the first time. The CHARGE LED locations.
will flash until the handset is laced
in the base cradle and the batteries
3. Never touch uninsulated telephone
are charged. wires or terminals unless the
telephone line has been
7. CHECK FOR A DIAL TONE. disconnected at the network
Afterthe batteries are charged, pick
interface.
up the handset and press the
PHONE key. The PHONE indicator
4. Use caution when installing or
should light up, and you should
modifying telephone lines.
hear a dial tone. If not, see IN
CASE OF DIFFICULTY.
CHECK
FOR A
DlAL TONE
on the base unit.