Legal Notices; Product Name; Fcc (Federal Communications Commission); Laser Safety - Canon imageRUNNER ADVANCE C2230 Manual

Legal Notices

Product Name

Safety regulations require the product's name to be registered. In some regions where this product is sold, the following name(s) in parenthesis
may be registered instead.
• imageRUNNER ADVANCE C2230/C2225 (F163100)

FCC (Federal Communications Commission)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate, radio frequency energy and, if not installed and used in accordance with the
Operator's Manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Use of shielded cables are required to comply with Class A limits in Subpart B of Part 15 of the FCC Rules.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If you make such changes or
modifications, you could be required to stop operation of the equipment.
If your equipment malfunctions, please contact your local authorized Canon dealer from whom you purchased the equipment (if under
warranty), or with whom you have a servicing contract. If you are not sure who to contact, and have both purchased and are using the
equipment in the U.S.A., please refer to the "SUPPORT" page on Canon U.S.A.'s Web site (http://www.usa.canon.com).

Laser Safety

This product complies with 21 CFR Chapter 1 Subchapter J as a Class I laser product under the U.S. Department of Health and Human Services
(DHHS) Radiation Performance Standard according to the Radiation Control for Health and Safety Act of 1968. Also, this product is certified as a
Class 1 laser product under IEC60825-1: 2007. This means that the product does not produce hazardous laser radiation.
Since radiation emitted inside the product is completely confined within protective housings and external covers, the laser beam cannot
escape from the machine during any phase of user operation. Do not remove protective housings or external covers, except as directed by the
equipment's manual.
The label shown below is attached to the paper drawer's right cover and toner supply port cover.
Use of controls, adjustments, or performance of procedures other than those specified in the manuals for this
machine may result in hazardous radiation exposure.
8