Table of Contents
Advertisement
Troubleshooting
The camera is a microcomputer-controlled
device. External noise and interference (from
a TV, a radio, etc.) might prevent it from
functioning properly.
The following phenomena are not
malfunctions.
• The camera heats up when it is used for a
long time.
• The battery heats up during charging.
• When playing back a video file, the
image stops momentarily or the sound is
interrupted at junctions between scenes.
• To solve the problem, first follow the
instructions below.
• If the problem is not solved, reset the
camera. (0' below)
.If the problem persists, please consult your
nearest JVC dealer.
• To reset the camera
1)
Set the power/mode switch to
OFF
and
remove the power supply (battery pack
or AC adapter) from the camera, then
reattach it.
2) Execute [PRESET] from the menu.
(0' pg. 69)
,
.'."
.,'
.
.... ' • Connect the AC adapter securely.
.No
po\y~ri$sllPp!ieCt:.:
•
Detach the battery pack once and re-attach it firmly.
. .
.. . , , ,
. . . ..
• Replace the dead battery with a fully charged one.
• If the camera is not operated for 5 minutes while the
power is on, it turns itself off automatically to conserve
power. To turn the camera on again when using the
battery pack, set the power/mode switch to OFF, then to
ON. When using the AC adapter, perform any operation
such as zooming.
• Adjust the brightness of the LCD monitor.
69
• Move to a place where not affected by vibration or
excessive sound.
• The drop detection function operated. Set the power/
69
mode switch to OFF, and to ON again. To turn off this
function, set [DROP DETECTION] to [OFF].
• Fully charge the battery, and then run it down. If the
16
problem persists, the battery is worn out and needs to be
replaced. Please purchase a new one.
• Make sure to use the camera under appropriate operating
79
temperatures.
• The battery is worn out and needs to be replaced. Please
purchase a new one.
• Charging may stop in places subject to extremely
high/low temperatures to protect the battery. It is
recommended to charge it in places with a temperature
of 10°C to 35°C (50°F to 95°F).
• When the battery is already fully charged, the lamp does
18
not light. Check the remaining battery power.
73
Advertisement
Table of Contents
