Programming The Memory; To Move The Seat To The Position That It Was In When Button 1 Was Programmed - Volvo XC90 User Manual

2005 VOLVO XC90
NOTE:
The seat will move to this position even if someone else has moved it to a different seating position
and locked the car with a different remote control.
This feature will work in the same way with all of the remote control transmitters (up to 3) that you
use with your vehicle.
This feature will not function if your lock your vehicle with the key.
pg. 61 Interior
WARNING!
- Because the driver's seat can be adjusted with the ignition off, children should never be left
unattended in the vehicle.
- Movement of the seat can be STOPPED at any time by pressing any button on the power seat
control panel.
- Do not adjust the seat while driving.
- The seat should be adjusted so that the brake pedal can be depressed fully. In addition, position the
seat as far rearward as comfort and control allow.
- The seat rails on the floor must not be obstructed in any way when the seat is in motion.

Programming the memory

Three different seating and door mirror positions can be stored in the driver seat's memory.
The following example explains how button 1 can be programmed.
Buttons 2 and 3 can be programmed in the same way.
To program (store) a seat position in button 1:
1. Move the seat to the desired position using the seat adjustment controls (see the previous page).
2. Press and hold down the MEM (memory) button.
3. With the MEM button depressed, press button 1 briefly to store the seat's current position.

To move the seat to the position that it was in when button 1 was programmed:

Press and hold down button 1 until the seat stops moving.
file:///K|/ownersdocs/2005/2005_XC90/05xc90_04a.htm (5 of 11)12/30/2006 4:42:30 PM