Volvo XC90 User Manual page 120

2005 VOLVO XC90
3. Without touching the accelerator pedal, turn the ignition key* to the starting position. Allow the
starter to operate for up to 10 seconds. Release the key as soon as the engine starts. If the engine fails to
start, repeat this step.
NOTE:
- On certain models, when the vehicle is started, idle speed may be noticeably higher than normal for a
short period, depending on the temperature of the engine.
This has been done to help bring components in the emission control system to their normal operating
temperature as quickly as possible, which enables them to function normally.
- For cold starts at altitudes above 6000 ft (1800 meters), depress the accelerator pedal halfway and turn
the key to the starting position. Release the pedal slowly when the engine starts.
4. To release the gear selector from the (P)ark position, the engine must be running (or the ignition key
must be in position II) and the brake pedal must be depressed.
5. Select the desired gear. The gear engages after a very slight delay which is especially noticeable when
selecting R.
NOTE: Your vehicle is equipped with a Keylock system. When the engine is switched off, the gear
selector must be in the (P)ark position before the key can be removed from the ignition switch.
When starting in cold weather, the transmission may shift up at slightly higher engine speeds than
normal until the automatic transmission fluid reaches normal operating temperature.
Do not race a cold engine immediately after starting. Oil flow may not reach some lubrication points fast
enough to prevent engine damage.
* If two of the keys to your vehicle are close together, e.g., on the same key ring, when you try to start
the vehicle, this could cause interference in the immobilizer system and result in the vehicle not starting.
If this should occur, remove one of the keys from the key ring before trying to start the vehicle again.
file:///K|/ownersdocs/2005/2005_XC90/05xc90_06a.htm (6 of 16)12/30/2006 4:42:33 PM