Volvo 2007 S80 Owner's Manual page 201

06 Maintenance and specifications
Wheels and tyres
Variant 1
Inflating tyres
3
2
06
5
4 8
1. Ensure that the orange switch
position 0 and take out the lead
hose from the side compartment
200
2. Unscrew the wheel's dust cap and
screw in the air hose valve connection
to the bottom of the thread on the tyre's
air valve.
3. Connect the lead
12 V sockets.
4. Start the engine.The car must be in a
well-ventilated place.
WARNING
Inhaling car exhaust fumes can result in
danger to life. Never leave the engine run-
ning in sealed areas or areas that lack suffi-
cient ventilation.
5. Start the compressor by flicking the
switch to position I.
6. Pump up the tyre to the pressure speci-
fied on the tyre pressure label.
7. Switch off the compressor, the
switch should be in position 0. De-
tach the air hose and unplug the lead.
Refit the dust cap.
8. Put the lead
side compartment
9. Put the puncture repair kit back under
the floor in the cargo area.
The compressor must not run for more than
is in
10 minutes. Let it cool afterwards as there is
and air
a risk of overheating.
.
Objects with a volume up to 50 litres can be
inflated with the compressor.
Sealing punctured tyres
to one of the car's
and air hose into the
.
1. Remove the decal
2. Ensure that the orange switch
3
2
1 6
regarding the high-
est permitted speed from the emergency
puncture repair kit and stick it on the
steering wheel where it can be clearly
seen by the driver.
position 0 and take out the lead
is in
and