Dimplex 6901860100 Parts & Service Manual page 12

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE FLICKER MOTOR/REFLECTOR ASSEMBLY
1. Unplug the unit from power outlet.
2. On the back of the unit, remove the 10 screws along the top, sides and bottom from
the Compact Fireplace, and the 2 screws from the light access cover that secure it to
the mantel.
3. Carefully remove the Compact Fireplace from the mantel holding onto the front glass
so that it does not move.
WARNING
The front glass is held to the Compact Fireplace with double sided tape and could come
apart when separated from the mantel
4. Remove the front glass and set aside.
5. Remove the log set screw and remove the log set.
6. Lay the Compact Fireplace on its back.
7. Remove the 4 bottom access panel screws and separate the bottom access panel
from the unit.
8. Locate and disconnect the 3 motor assembly wires going to the terminal block.
9. Remove the 2 motor mounting screws.
10. Separate the motor from the flicker connector and remove.
11. Slide the reflector assembly out of the snap-in bushing and remove.
12. Reassemble in the reverse order as above.
REFLECTOR
ASSEMBLY
FLICKER CONNECTOR
11
FLICKER MOTOR