Table of Contents
Advertisement
3. In the bottom hole, install a bolt (3/8 x 1–1/4 in.) and a
flange nut (3/8 in.) (Fig. 4).
4. Install a bracket stiffener to the side bracket and bagger
mounting bracket. Use 4 bolts (3/8 x 3/4 in.) and 4
flange nuts (3/8 in.) (Fig. 4).
5. Repeat the previous steps for the opposite side (Fig. 4).
6
4
3
1
9
8
Figure 4
1. Bagger mounting bracket
2. Bolt, 3/8 x 1–1/4 in.
3. Flange nut, 3/8 in.
4. Bracket stiffener
5. Left side bracket
Installing the Bagger Mounting Bracket
onto a Liquid Cooled Machine
1. Install the bagger mounting bracket to the rear frame of
the machine (Fig. 5).
2. In the top two holes, install 2 bolts (3/8 x 1–3/4 in.) and
2 flange nuts (3/8 in.) (Fig. 5).
3. In the bottom two holes, install 2 bolts (3/8 x 1–1/4 in.)
and 2 flange nuts (3/8 in.) (Fig. 5).
5
10
3
7
4
3
7
6
2
m–5979
6. Bolt, 3/8 x 3/4 in.
7. Long frame spacer
8. Bolt, 3/8 x 1–1/2 in.
9. Short frame spacer
10. Right side bracket
4
1
5
2
5
2
Figure 5
1. Bagger mounting bracket
2. Bolt, 3/8 x 1–1/4 in.
3. Flange nut, 3/8 in.
Installing the Side Brackets to
the Machine
The following instructions are for both air cooled and
liquid cooled.
Important
Do not tighten any bolts until both side
brackets and bagger mounting bracket are fit loose on the
machine.
Refer to Tightening the Mounting Bolts, on page 8, for the
correct procedure to tighten the bolts.
Note: Hydraulic lines may need to be adjusted when
installing the side brackets onto the machine. This will
allow for fastener clearance.
1. Install the side plates to the side of the mower using 6
bolts (3/8 x 1 in.), 6 curved washers (3/8 in.), and 6
flange nuts (3/8 in.) (Fig. 6).
Note: Make sure the curved washers are installed as shown
in figure 6.
7
3
3
m–5864
4. Bumper
5. Bolt, 3/8 x 1–3/4 in.
Advertisement
Table of Contents
