Installation; Install Blower Tube; Remove Blower Tube; Before Starting - Toro Power Sweep 51586 Operator's Manual

Installation

Install Blower Tube

1. Slide tube onto blower outlet until tabs on tube
snap into latch (Fig. 3).

Remove Blower Tube

1. Depress tabs on top and bottom of tube to
release tabs from latch (Fig. 3). Slide tube off
blower outlet.

Before Starting

Securing Power Supply Cord

Use only a UL listed (CSA certified in Canada)
extension cord recommended for outdoor use. Refer
to Extension Cord Chart.
EXTENSION CORD CHART
If length of extension cord is
less than or equal to:
Assure wire size gauge
(A.W.G.) in cord is:
Note: Use of an extension cord over 150 feet
is not recommended.
POTENTIAL HAZARD
Contact with water while operating unit
could cause electric shock.
WHAT CAN HAPPEN
Electric shock can cause injury or death.
HOW TO AVOID THE HAZARD
Don't handle plug or appliance with wet
hands or while standing in water.
Use only a UL listed (CSA certified in
Canada) extension cord recommended for
outdoor cold weather use. Refer to
Extension Cord Chart, page 4.
100 ft. 150 ft.
16 14
To reduce the risk of electric shock, this appliance has
a polarized plug (one blade is wider than the other)
(Fig. 4). This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, consult a
qualified electrician to install the proper outlet. Do
not change the plug in any way.
1. Form a loop in extension cord and insert it
through slot in rear of blower housing (Fig. 5).
2. Secure extension cord in cord lock (Fig. 5 & 6).
POTENTIAL HAZARD
The extension cord may not be fully seated
on inlet plug.
WHAT CAN HAPPEN
A loosely connected extension cord could
lead to overheating and cause a fire.
HOW TO AVOID THE HAZARD
Make sure the extension cord is fully seated
on inlet plug and ALWAYS USE THE
CORD LOCK FEATURE to ensure that
cord remains secured during operation
(Fig. 5 & 6).
Note: Do not unplug extension cord by
pulling on cord. To unplug, grasp the
plug, not the cord.
POTENTIAL HAZARD
The electrical cord could be damaged.
WHAT CAN HAPPEN
A damaged electrical cord could cause a
shock or fire.
HOW TO AVOID THE HAZARD
Thoroughly inspect electrical cord before
using unit. If cord is damaged, do not
operate unit. Replace or repair damaged
cord immediately. Contact your TORO
service dealer for assistance.
EN–4