Table of Contents
Advertisement
the pressure gauge. Use a hex wrench to screw the
reducer assembly to the pressure gauge (Figure 13).
1. Pressure gauge
2. Wrapped threads
3. Plastic nut
13. Install the pressure gauge assembly to the plastic tee
(Figure 13).
14. Install the large plastic nut over the pressure gauge
and tee assembly. Install a plastic O-ring and adapter
to the assembly as shown in Figure 14.
1. Gauge tee assembly
2. Adapter
15. Lubricate the O-ring in the adapter with a
non-petroleum based lubricant, such as vegetable
oil (Figure 15).
16. Install the pressure gauge assembly to the forward
facing opening in the control valve installed
Figure 13
4. Reducer
5. Lubricate O-ring
6. Tee
Figure 14
3. O-ring, plastic
4. Large plastic nut
previously (Figure 15). Tight the plastic nut to secure
the assembly to the valve.
1. Pressure gauge assembly
2. Large plastic nut
17. Install a plastic O-ring between the pressure gauge
assembly and hose leading to the reel assembly.
Connect the hose to the assembly (Figure 16).
Tighten the plastic nut on the hose to secure it to the
pressure gauge assembly.
1. Hose, from reel
2. Control valve
8
Figure 15
3. Control valve, open
4. Lubricate O-ring
Figure 16
3. Gauge assembly
4. O-ring, plastic
Advertisement
Table of Contents
