Installing The Control Valve - Toro 41135 Installation Instructions Manual

1. Power wire from the
electrical box on the hose
reel.
11. Connect the black wire to a post on the ground
terminal block, located under the solenoid.
3

Installing the Control Valve

Parts needed for this procedure:
1 Control valve
1 Retaining fork
1 Control valve bracket
2
Flange bolt (1/4 x 3/4 inch)
2 Flange nut (1/4 inch)
2 Screw
1 Pressure gauge
1 Plastic nut
1 Reducer
1 Tee
2 Plastic O-ring
1 Adapter
1 Plastic nut, large
1 Hose assembly
Procedure
1. Locate the valve assembly on the right side of the
tank, remove the retaining fork to disconnect the
boom supply hose from the supply tee (Figure 7).
Figure 6
2. Solenoid
1. Supply tee
2. Retaining fork
2. On a Multi-Pro 1200 Sprayer, disconnect the small
red pressure gauge tube from the green tube fitting
on top of the supply tee (Fig. 8). To disconnect,
press down on the tube fitting while pulling up on
the tube.
3. Remove the two bolts and two nuts securing the
supply tee and supply tee mounting bracket to the
vehicle (Figure 8). Retain the fasteners for later use.
1. Supply tee mounting
bracket
2. Tank strap
4. Install the new control valve into the rear facing
open port on the supply tee and secure it with a new
retaining fork (Figure 9).
6
Figure 7
3. Boom supply hose
Figure 8
3. Bolt
4. Nut