Lubrication; Greasing Bearings And Bushings - Toro ProCore Operator's Manual

Lubrication

Greasing Bearings and
Bushings
Service Interval: Every 50 hours
The core processor has (18) grease fittings that must
be lubricated regularly with No. 2 General Purpose
Lithium Base Grease. Lubricate the chopper, rear roller
and rotating corner bearings immediately after every
washing.
1. Lubricate the following grease fittings:
• Tow frame, Qty 2 (Figure 40)
• Lift cylinder, Qty. 2 (Figure 39 & Figure 42)
• Lift axle, Qty. 2 (Figure 39)
• Jack shaft, Qty. 2 (Figure 42)
• Chopper assembly, Qty. 2 (Figure 43 & Figure 41)
• Rotating corner, Qty. 2 (Figure 43 & Figure 41)
• Pickup brush, Qty. 2 (Figure 43 & Figure 41)
• Rear roller, Qty. 2 (Figure 41)
Figure 39
34
Figure 40
Figure 41