Table of Contents
Advertisement
Specifications
Note: Specifications and design are subject to change without notice.
Overall width
Brush width
Chopper width
Length with out tow hitch
Length with 3 point tow hitch
Length with offset hitch
Transport height ground clearance
Wheel base width
Weight
Special Instructions for Workman and
other utility tow vehicles (tractors)
• The Toro ProCore Processor can be towed by most
utility tractors equipped with hydraulics producing
7 to 8 GPM @ 2000 p.s.i. The tractor must have
adequate brakes and drawbar hitch capacity to handle
a 2000 lb (907 kg) trailer. Refer to Tractor Operator's
Manual for towing instruction and precautions
• The Workman vehicle must be equipped with
remote hydraulics producing 3 to 4 GPM @ 2000
psi and the Heavy Duty Drawbar (Model 44212 or
44213). (The 4 wheel drive model is the best for
hilly or bermed approaches to greens). Also, it is
recommended that 500 lb of additional weight be
added to the Workman bed.
Tow Vehicle
Minimum
GPM
Workman
3
Vehicle
Tractor
7
Important: Do Not attempt pulling the core
processor with the standard Workman hitch. It
is only rated to 1500 lb and may bend or damage
the cross tube axle support or rear spring
shackles. Always use the Heavy Duty. Drawbar
Kit Model 44212 or Heavy Duty. Frame Drawbar
Model 44213.
• The Core Processor is not equipped with trailer
brakes. Maximum transport speed must not exceed
15 mph.
Maximum
Relief
GPM
Pressure
4
2000 psi
8
2000 psi
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
21
88 inches (224 cm)
70 inches (178 cm)
70 inches (178 cm)
70 inches (178 cm)
133 inches (338 cm)
159 inches (404 cm)
12 inches (30 cm)
69 inches (175 cm)
2000 lb. (907 kg)
Advertisement
Table of Contents
