DeWalt D25413 Instruction Manual page 8

HAMMERDRILL MODE "" "r
To use hammerdrill mode, press the mode selector button (H) and
turn the mode selection dial (G) so the yellow arrow points to the
corresponding symbol as shown. Use this mode for masonry drilling.
HAMMER-ONLY MODE T
For light chiseling, press the mode selector button (H) and turn
the mode selection dial (G) so the yellow arrow points to the
corresponding symbol as shown.
NOTE: The yellow arrow on the mode selection dial MUST be
aligned with the one of the symbols at all times. There are no
operable positions between the positions.
E=Clutch and Indicator Light (Fig. 4)
(D25415 ON LY}
The e-clutch offers increased user FIG.4
comfort and safety through an
on-board anti-rotation technology
capable of detecting if the user loses J
control of the hammer. When a jam is
detected, the torque and speed are
reduced instantly. This feature prevents
self rotation of the tool reducing the
occurrence of wrist injuries.
The red indicator LED (J)lights up the electronic clutch is engaged in
any mode except the chipping mode.
Quick Change SDS Chuck (Fig. 5)
(D25415 ONLY) FIG.5
The SDS chuck can be easily removed
by turning the collar (K) into the
unlocked position to release the chuck.
The SDS chuck can be easily attached
by inserting the chuck into the spindle
of the tool and turning the collar to the K
locked position. The chuck will click
when properly installed.
Inserting and
Removing SDS Plus ®
Accessories (Fig. 1)
A WARNING: Burn hazard. ALWAYS wear gloves when changing
bits. Accessible metal parts on the tool and bits may get extremely
hot during operation. Small bits of broken material may damage bare
hands.
_, WARNING: Do not attempt to tighten or loosen drill bits (or any
other accessory) by gripping the front part of the chuck and turning
the tool on. Damage to the chuck and personal injury may occu_
To insert bit, insert shank of bit about 3/4" (19 mm), no further than
7/8" (22 mm) into chuck. Push and rotate bit until it locks in place. The
bit will be securely held.
To release bit, pull the chuck (F)back and remove the bit.
OP£RATION
A WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.