A.O. Smith Theta T Series Installation, User And Service Manual page 71

Installation diagram: Theta dual service with a SGE - Unvented.
Legend
1. pressure relief valve (mandatory if the
mains water pressure is too high)
3. T&P valve (mandatory)
4. stop valve (recommended)
5. non-return valve (mandatory)
6. circulation pump (optional)
9. drain valve
10. manual gas valve (mandatory)
11. service stop valve (recommended)
12. temperature gauge (optional)
13. condensation drain
14. draw-off point
15. expansion valve (mandatory)
16. expansion vessel (mandatory)
20. heating pump (mandatory)
Installation-, User- and Service Manual
22. radiator
23. pressure valve (mandatory)
26. heating filling tap (recommended)
32. floor heating
33. room thermostat
37. combined Q/T sensor (optional)
38. solar heating pump station
(modulating - mandatory)
40. DHW-pump
42. control solar heating system
56. pressure valve (recommended)
57. filling and draining valve (mandatory)
59. 3-way mixing valve (mandatory)
A. cold water supply
B. hot water supply
C. circulation pipe
D. gas supply
F. supply heat exchanger
G. heat exchanger return
IMD-1128b R0.0
 hot water supply 3-way mixing valve
from water heater
 outlet 3-way mixing valve to plate heat
exchanger
 return water to 3-way mixing valve
from plate heat exchanger
S collector sensor
1
S tank sensor
2
S solar heating system return sensor
4
(optional)
S heating system sensor
5
71