Horn; Head Light; Inspection And Control Of Cables And Handles - Texas A/S Cruise 250 2005 User Manual

3. (symbol C) - Steering wheel lock. Turn the steering wheel all the way to the left. Push the
key and then turn the key to C (LOCK-symbol). You may need to turn the steering wheel a
little from side to side to find the right position for the lock. Do not push the key when
unlocking. Just turn the key to the right.
4. (Symbol D) - Parking light. May only be used, when the lock is activated.

Horn

Press the button (2) and the horn sounds. Only use the horn, when it is necessary.

Head light

The button (15) has 3 positions:
Right: the light is off
Middle: parking light
Left: dipped head light
The long light is activated by pressing the button on the left handle (6).
Always check that the lights are turned on before you drive the cruiser.

Inspection and control of cables and handles

Check that handles and cables move smoothly. There must be no bends or rust on the cables. The
cables must be lubricated regularly. Use oil type LPS 2 or similar. If the cables do not move
smoothly despite being lubricated well, they must be replaced.
Idling of the throttle should be 2-6 mm. Minor adjustments may be made on the upper part of the
cable. Major adjustments may be made just above the carburettor.
Adjustment of the idling is done like this: Start the engine and let it run warm. Adjust the idling
screw until the engine runs evenly. Turn the screw clock-wise and the revolutions decrease. When
you turn the screw anti-clock-wise the revolutions increase.
The idling of the clutch handle must be 2-3 mm. If adjustment is necessary you loosen the nut on
the cable. Tighten or loosen the cable and tighten the nut again. Start the engine and pull the
clutch handle and go into gear. The cruiser must not move. Release the clutch handle slowly and
the cruiser moves forward. If the cruiser does not move forward after adjustment you should
contact your authorized dealer.
Maintain the chain by lubricating it regularly, minimum for every 500 km or more often if
necessary. Use type LPS 2 or similar.
7