Transfer (Boats Equipped With Dual Helms); Dock Mode - Mercury Axius Manual

Joystick piloting for sterndrives
Hide thumbs Also See for Axius:
Table of Contents

Advertisement

Section 2 - On the Water
Control
Trim control
Raises and lowers the drives for best efficiency, or for conditions such as shallow water or trailering.
Illuminate when the engine is in the neutral gear position. The lights flash when the engine is in
NEUTRAL (lights)
throttle‑only mode.
Limits the boat to idle forward at an idle speed up to a specific RPM that is programed into the PCM or
vessel personality. Use the + and – buttons to increase or decrease the speed.
NOTE: The troll feature is not available on some ERC‑mounted trackpads, only dash‑mounted. For
TROLL
vessels equipped with ERC‑mounted trackpads that do not have a troll button, the troll feature can be
accessed from VesselView.
Allows boat control to be transferred to a different helm. Refer to Helm Transfer.
TRANSFER
Available during joystick and ERC operation.
DOCK
Allows the boat operator to increase engine RPM without shifting into gear. Refer to Throttle‑Only
THROTTLE ONLY
Mode.
Enables the throttle and shift functions of all engines to be controlled by the port lever. Refer to Single
1 LEVER
Lever Mode.
Turns the auto‑synchronization feature off or on. Refer to Synchronizing Engines.
SYNC
Increases and decreases brightness settings for the trackpad, VesselView display, and SmartCraft
+ (increase) and
gauges.
– (decrease)
NOTE: On dash‑mounted DTS trackpads, these buttons increase or decrease the trolling speed.

Transfer (Boats Equipped with Dual Helms)

The transfer function allows the boat operator to transfer control of the boat from the active helm to the inactive helm on boats
equipped with dual helms. Refer to Helm Transfer.

Dock Mode

Dock mode reduces the RPM throughout the throttle lever range by 50%, allowing finer control of engine power in close quarter
situations. If more power is needed for vessel maneuvering when environmental conditions require more thrust, do not use
Dock mode.
NOTE: When the joystick is enabled while in dock mode, dock mode reduces available power to 70% of the already reduced
power with the joystick.
To engage dock mode:
1.
Place both ERC levers in neutral.
2.
Press the dock button located on the DTS trackpad.
3.
The dock light turns on.
4.
Place either ERC lever into gear.
Page 10
Joystick operation reduces throttle capacity to approximately 70% of normal joystick throttle
demand.
Control lever throttle capacity is reduced to approximately 50% of normal control lever throttle
demand.
Transfer button and light
Function
51858
90-8M0099745
MAY 2015
eng

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents