Table of Contents
Advertisement
6 USB connectors (USB, ×3)
Connect Control Panels. (USB cables are supplied
with each Control Panel.)
7 Line I/O connectors (minijack)
Allow you to make line connections to external audio
equipment. The upper connector is for input, and the
lower connector is for output.
Use an optional cable with stereo miniplugs to connect
the output connector to the AUX2 connector of the AV
I/O section.
4 AGP/PCI slot section
6 Graphics board
1 SDTI Interface Board
Installation of an SDTI Interface Board provides four
additional BNC connectors, enabling one SDTI input
channel and one SDTI output channel, plus one
reference signal input channel and one loop-through
reference signal output channel.
Note
The SDTI Interface Board is an optional board.
.........................................................................................................................................................................................
1) Option
HD SDI
IN
HD SDI
OUT
REF IN
AGP
PCI1
PCI2
PCI3
5 HDTV Interface Board
1)
8 Microphone/Headphones connectors (minijack)
Connect a microphone to the left connector and
headphones to the right connector.
9 Serial port 1 connector (D-sub 9-pin)
Connect a modem or other device with a serial port
connector.
REF
REF IN
IN B
OUT B
SDTI IN
IN A
SDTI OUT
OUT A
1 SDTI Interface Board
PCI4
PCI5
2 AV Processing Board
3 Realtime Video Processing Board/
SDTV Realtime Proscessing Board
4 2Gb Fibre Channel Interface Board
(LSI44929o)
2 AV Processing Board
Provides five BNC connectors, for two SDI inputs,
two SDI outputs, and a reference signal input.
Connect the individual connectors as follows:
• the OUT A connector to the SYSTEM I/F IN
connector of the AV I/O Block
• the IN A connector to the SYSTEM I/F OUT
connector of the AV I/O Block
• the IN B connector to a second VTR
• the REF connector to the VP REF OUT connector of
the AV I/O Block.
Chapter 2 Names and Functions of Parts
2-7
Advertisement
Table of Contents
Troubleshooting
