Toshiba TECRA A10/S10/M10/SATELLITEPRO S300 TECRA S10 User Manual page 80

TECRA A10/S10/M10/SatellitePro S300
Take care to ensure that the memory module cover is firmly closed.
10. Install the battery pack - refer to
Chapter 6,
11. Turn your computer over.
External monitor
An external analog monitor can be connected to the external monitor port
on the computer. To connect a monitor, follow the steps as detailed below:
Connecting the monitor cable
1. Turn the computer's power off.
2. Connect the monitor cable to the external monitor port and tighten the
screws on the left and right hand side of the connector as required.
3. Turn the external monitor's power on.
4. Turn the computer's power on.
When you turn on the power, the computer will automatically recognize the
monitor and determine whether it is a color or monochrome device. In the
event that you find that there are issues getting an image displayed on the
correct monitor, you should consider using the FN + F5 hot key to change
the display settings (if you then disconnect the external monitor before you
turn the computer's power off, be sure to press FN + F5 hot key again to
switch to the internal display).
Please refer to Chapter 5,
keys to change the display setting.
Do not disconnect the external monitor while in Sleep or Hibernation Mode.
Turn off the computer before disconnecting the external monitor.
3-28
Power and Power-Up
External monitor port
Figure 3-12 Connecting the monitor cable to the external monitor port
Replacing the battery pack
Modes, if required.
The Keyboard, for further details on using hot
section in
Monitor cable
User's Manual