Installation; Care And Cleaning - Sharp SJ-BW30P Operation Manual

INSTALLATION

•
WARNING
Do not install the refrigerator in a damp or wet
location as this may cause damage to the
insulation and a leak. Condensation may also
build on the outer cabinet and cause rust.
Keep adequate ventilation space around the refrigerator.
•
The figure shows the minimum required space for
installing the refrigerator. It differs from the space in
the measurement condition of the amount of power
consumption.
•
It is possible to use the refrigerator with a less amount
of power consumption by keeping greater space.
•
If using the refrigerator in the space below dimension
of the figure, it may cause the temperatures in the unit
to rise, loud noise, and failure.
60mm
or more
1000mm
60mm
or more
Free standing type
NOTE :
• Position your refrigerator so that the plug is accessible.
• Keep your refrigerator out of direct sunlight.
• Do not place next to heat generating appliance.
• Do not place directly on the ground. Provide suitable
stand.
Allow the refrigerator for 2 hours before plug.
•
•
When transporting, carry the refrigerator by holding
the back and stand.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
Before transporting
• Wipe up water in the evaporating pan. Before wiping up
the water, wait more than 1 hour after pulling out the plug
because refrigeration cycle equipment is extremely hot.
(The evaporating pan is located on the rear of the product.)
NOTE :
• Do not bend or damage the ductwork located on the inside
of the evaporating pan. It may cause failure.
60mm
or more
1390mm
90mm
or more
60mm
or more

CARE AND CLEANING

•
WARNING
•
Unplug the refrigerator first to prevent electric shock.
Do not splash water directly on the outer cabinet
or the interior. This may lead to rusting and
deterioration of the electrical insulation.
IMPORTANT
To prevent cracking on inside surfaces and plastic
components, follow these tips.
•
Wipe any food oils adhered to plastic components.
•
Some household chemicals may cause damage, so use
only diluted washing-up liquid (soapy water).
•
If undiluted detergent is used or soapy water is not wiped
off thoroughly, cracking of plastic parts can result.
1. Remove the shelves and pockets from the cabinet and
door. Wash them in warm soapy dishwashing water;
rinse in clean water and dry.
2. Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water.
3. Wipe the exterior with a soft cloth each time it is soiled.
4. Clean the Magnetic door seal with a toothbrush and
warm soapy dishwashing water.
NOTE :
• To prevent damage to your refrigerator, do not use heavy
duty cleansers or solvents (lacquer, paint, polishing powder,
benzine, boiled water, etc.).
•
If the power supply is disconnected, please wait for at least
5 minutes before re-connecting power.
•
Do not drop objects inside the refrigerator or strike the inner
wall. This may cause the inner surface to crack.
When the compartment light is blown
Contact the service agent approved by SHARP to request a
replacement compartment light. The compartment light is not
to be removed other than by qualified service personal.
Switching off your refrigerator
If you switch your refrigerator off when you are going away
for an extended period, remove all food, clean the interior
thoroughly. Remove the power cord plug from the power
socket and leave all doors open.
How to remove Vegetable case
1.
Remove the vegetable case.
2.
Remove the vegetable case door.
3.
Remove the vegetable shelf.
12