Graco Silhouette Instructions Manual page 11

GB
Instructions
Assembly
See images
1
To Use Vibrator
Remove battery lid, found under seat, with a
13
key and insert1-D-LR20 (1.5V) battery in
module. Replace lid.
Push button to low or high.
14
Attaching Tray
Insert bottom of peg into opening on side
15
of seat, as shown.
Rotate tray to close or open.
16
Attaching Seat Pad
Pull harness straps and crotch strap through
17
slots in the back of seat pad.
Pull back of seat pad over back of seat.
18
Pull sides of seat pad around edge of seat
19
and over vibration unit.
Fasten two elastic loops attached to the
20
seat pad to the two tabs on both sides of
the seat as shown.
Attaching Seat to Frame
See images –
21
Slide swing seat onto the top brackets.
Secure swing seat by pushing down gently,
the arms will snap into place.
Head Support
Only use this head support on this swing.
23
Never use this head support on any other
product.
To Adjust Recline
Press in recline buttons on each side of seat
24
to lower.
Press in recline buttons on
25
each side of seat to raise seat.
-
12
22
For Storage
Press buttons on each side of swing to remove
34
front legs for storage.
To Secure Your Child
See Images
27
WARNING Falling Hazard: Always use the
seat belt.
Use slide adjuster at shoulder and waist for
32
further adjustment. Repeat on other side.
When changing harness strap slots, MAKE
33
SURE harness straps are going through same
slots in seat pad and seat back.
The harness straps must go into the slot
34
that is even with or slightly above the shoul-
ders. Avoid twisting
Installing Batteries
See Images
35
With baby out of swing, open the battery
compartment lid by unfastening screw.
Insert four "D"-LR20 (1.5V) batteries.
Replace battery lid.
11
–
34
straps.
–
36