Table of Contents
Advertisement
g. Press the
Scan is highlighted.
h. Use the
search. When finished, "Auto
Scan Completed" will be displayed
at the top of the screen.
This will take a few minutes to
complete.
i.
To add or delete a channel press the
buttons until the desired channel number is shown.
j.
Press the
option. Use the
k. Press the MENU button repeatedly to exit the On Screen Display (OSD).
6. Using DTV with an Antenna or Cable
To use the Digital TV option, you will need to
select DTV using the INPUT button on the
remote or side of the Plasma TV, or directly by
pressing the TV button on the Remote Control.
The first time you use your DTV input you will
see the information panel, "Channel Scan
Required Press Menu" Press the MENU button
and follow the procedure in Section 3.4 DTV
Tuner Setup.
Note: DTV digital broadcast is not available in all areas. Refer to
www.antennaweb.org
which direction to point your antenna. The channel availability through cable depends upon
which channels your cable operator supplies in Clear QAM; consult your cable operator for more
information.
7. Using a PC
If connecting to a PC through the RGB PC input, set the TV timing mode to VESA 1024x768 at
60Hz for best picture quality (refer to the graphic card's user guide for questions on how to set
this timing mode).
Version 4/17/2007
button until Auto
button to start the
Note:
button to highlight Set Channel and then press the
or
buttons to Add or Skipped.
to get information about availability in your area, type of antenna and in
30
www.VIZIOCE.com
VIZIO VP50HDTV User Manual
button to highlight CH and then press the
or
button the select this
Advertisement
Table of Contents
