Black & Decker CCS818 Instruction Manual page 12

Switch
• Always be sure of your footing and grip the chain saw firmly with
both hands with the thumb and fingers encircling both handles.
• To turn the tool ON push the lock
off button (2) to either side and
squeeze the trigger switch (1) with
your fingers as shown in
figure N. (Once the tool is running
you can release the lock off
button.)
• To turn the toot OFF, release the
trigger switch.
Chain Braking System
Your chain saw is equipped with a motor chain braking system which
will stop the chain quickly each time you release the trigger. This
system should be tested before every use.
Saw Chain Sharpness
The cutters wilt dull immediately if they touch the ground or a nail
while cutting. Refer to "Sharpening the Chain".
Saw Chain Tension
This should be done regularly. Refer to "Adjusting Chain Tension".
Common Cutting Techniques
Felling
Felling is the process of cutting down a tree. Be sure battery is
fully charged before felling a tree so you can finish on a single
charge. Do not fell trees in high wind conditions.
Bucking is the process of cutting a felled tree or log into lengths.
When bucking and felling operations are being performed by two
or more persons, at the same time, the felling operation should be
separated from the bucking operation by a distance of at least
twice the height of the tree being felled. Trees should not be felled
in a manner that would endanger any person, strike any utility line
or cause any property damage. If the tree does make contact with
any utility line, the utility company should be notified immediately.
12
Scrutinize the surrounding overhead for dead or broken limbs or
branches which may fall during the felling process.
The chain saw operator should keep on the uphill side of the
terrain as the tree is likely to roll or slide downhill after it is felled.
• (Figure O) A retreat path
should be planned and
cleared as necessary before
cuts are started. The retreat
path should extend back and
diagonally to the rear of the
expected line of fall.
• Before felling is started,
consider the natural lean of
the tree, the location of
larger branches and the
wind direction to judge which
way the tree will fall. Have
O
_45°
\
RETREAT
DIRECTION
OF
_, FALL
_REE
wedges (wood, plastic or aluminum) and a heavy mallet handy.
Remove dirt, stones, loose bark, nails, staples, and wire from the
tree where the felling cuts are to be made.
(Figure P) Notching
A
Undercut - Make the
notch 1/3 of the (5cm)
diameter of the tree, DIRECTION qCHES FELLING BACK
perpendicular to the OF FAL_L - I I CUT
direction of the fall. -I I-
Make the lower I I J 2 (5cm)
horizontal notching cut -'X_ _ tlNCHES
first. This will help to NOTCH -- --- --T-
avoid pinching of either _ _.__HINGE
the saw chain or the
guide bar when the
second notch is being made.