Maintenance - JVC KD-BT11 Instructions Manual

Maintenance
Center holder
~
Stick-on label
Sticker and
sticker residue
~
~
Unusual shape
Do not use the following discs:
Single CD
-3-3/16" (8 cm) disc Warped disc
~ ~
• To play new discs
New discs may have some rough spots
around the inner and outer edges. If
such adisc is used, this unit may reject
the disc.
To remove these rough spots,
rub the edges with a
pencil or ball-point pen, etc.
• To keep discs clean
Adirty disc may not play correctly.
Ifadisc does become dirty, wipe it with
asoft cloth in astraight line from center
to edge.
• Do not use any solvents (for example, conventional
record cleaner, spray, thinner, benzine, etc.) to clean
discs.
When removing adisc from its
case,
press down the center holder of
the case and lift the disc out, holding
it by the edges.
• Always hold the disc by the edges. Do not touch its
recording surface.
When storing adisc in its case, gently insert the
disc around the center holder (with the printed surface
facing up).
• Make sure to store discs in cases after use.
• How to handle discs
• Moisture condensation
Moisture may condense on the lens inside the unit in
the following cases:
• After starting the heater in the car.
• Ifit becomes very humid inside the car.
Should this occur, the unit may malfunction. In this
case, eject the disc and leave the unit turned on for a
few hours until the moisture has evaporated.
• How to clean the connectors
Frequent detachment will deteriorate the connectors.
To minimize this possibility, periodically wipe the
connectors with acotton swab or cloth moistened with
alcohol, being careful not to damage the connectors.
~
~
Connectors
REFERENCES
35