Video Connections; Video Source Connection; Tv/Monitor Connection - JAMO AVD4.6 Installation Manual

Cat5e
AM4.6
TV Sub-zone
Cat5e
AM4.6

Video connections

VM4.6
Video Connection(s)
RCA - RCA cables
Source equipment
Fig. 4
TV Main zone
VM4.6
Fig. 5

Video Source Connection

A total of six video sources may be
connected to the VM4.6.
The video output of the source
equipment is connected to the RCA
sockets on the VM4.6 labeled video
inputs 1-6. Use quality 75 ohm coax-
ial cable with RCA plugs in each
end.
The control signals are sent over the
CAT5e cable as described below.

TV/Monitor Connection

If video distribution is also part of
the system the VM4.6 is connected
to the AM4.6 with a CAT5e cable.
The CAT5e cable is connected at
both ends with an RJ45 plug to the
expansion sockets. This provides
power to the VM4.6 and input
switching commands from the
KP4.6 wall keypads or RC4.6 system
remote control.
The TV/Monitors are connected
with RG6 or other coax cable using
RCA plugs to the main or sub-zone
sockets on the VM4.6
7