Audio Connections - JAMO AVD4.6 Installation Manual

6
AM4.6
Speakers
Sub-zone
AM4.6

Audio connections

Jamo emitter(s)
Audio Connection(s)
RCA - RCA cables
Fig. 2
Speakers
Main zone
PS24
Sub-zones
(if installed)
KP4.6
Cat5e
PS24
Main zones
Fig. 3
Audio Source Connections
It is possible to connect a total of six
audio source components to the
AM4.6. The connections are made
from a line level output on the source
equipment to one of the six inputs on
the AM4.6 using RCA to RCA cables.
Remote control
The source equipment can be remote
controlled from all main and sub-
zones with the remote control sup-
plied with the source equipment.
Source equipment
An IR emitter is used for each source
component. The IR emitter is plugged
in to the appropriate IR output on the
AM4.6 and the emitter itself is stuck
onto the source equipment in front of
the receiving sensor.
The ALL COMMANDS sends remote
signals from any remote control, and
not only from the remote control as-
sociated with the source selected.
Two Jamo IF5 emitters are included
with the AVD4.6 system.
PS24 to AM4.6
Each AM4.6 requires one PS24 for the
four main zones. In addition it needs
another PS24 if any sub-zones are
connected. Fig. 2.
KP4.6 to AM4.6
Each KP4.6 is connected to the AM4.6
using a CAT5e cable. It is plugged in
to the AM4.6 using an RJ45 plug, and
connected to the KP4.6 via a 8-way
color coded screw terminal.
Main zones and sub-zones are deter-
mined by choosing a main zone or
sub-zone socket on the AM4.6.
KP4.6 to Loudspeakers
Use a pair of high-quality speaker ca-
ble to connect the KP4.6 to any pair of
in-wall, ceiling or other suitable
speakers.
See the manual supplied with the
KP4.6 for complete installation in-
structions.