How To Use Osd; Before Use Osd, You Must Know - Vivitek DVR5612 User Manual

Before use OSD, You must know:

Recommended ways to learn about operations
Before starting, please follow the suggested steps to understand the fundamentals of operating the display,
and then you will be able to learn the operations in a short time:
1.Please first learn to power on and power off the display. Refer to page 18 for the descriptions of the
operations.
2.Please learn how to operate the OSD.
3.Understand what each OSD menu is. Refer to page 20~28 for an explanation of the
OSD contents.
Example how to select correct input signal source.
After power on the display, first step: you need to select the correct input signal source. The screen will be
blank without any images with incorrect input signal source. Follow the steps to set up:
1.Use OSD to select the correct input source, press the
2.Use ▲▼ keys to select the "INPUT SETUP" option , press OK to enter the submenu.
3.Then the OSD will show the Submenu as below:
OK
4.Press , then press
the main input source, last press
exit this main input setup.
5.Now you understand:
MENU
Just to press the
And follow the OSD buttom line's information to operat the OSD. So you only need
▲▼ ◄► , ENTER
If you still have any question, please call our service center to help you.
Quick Input Source select way
For Main Input
INPUT
Press the key in the front control panel or remote control repeatedly, the input signal mode will appear on
the top left corner, please select correct input signal mode.(Refer to Input relative page 13~15,24) COMP
For PIP Input
Please refer to page 24.
Press
Follow the OSD's indicate to operate the OSD.
For example:
.Use
INPUT" or "INPUT SIGNAL"
2.then use
◄ ►
to change
OK
again to
3.If you want to exit the submenu, press
control to main menu or
key to show the OSD
these keys to control the whole OSD.

How to use OSD

MENU
key and bring up the OSD menu.
OK
to enter the Submenu
▲▼
key to select the item "Main Input" , "PIP
OK
to enter the item that you select.
▲▼
eg: use to select MAIN INPUT, press
◄ ►
to select input source TV, DTV....
Menu
ok
then use
EXIT
on remote
key to exit OSD.
MENU, EXIT , OK,
8