5.2.4
Influence of the wind
Be careful if there is a strong wind blowing. Wind may seriously affect the flames.
In that case:
• Flames may be stifled underneath the burner box.
Sometimes, the burner must be turned up in order to avoid the flames from
being stifled.
• The flames underneath the burner deck may be blown out.
In that case, the work must be stopped immediately because this will
endanger the tool carrier and the surroundings.
If there is too much wind, stop working with the
HOAF WeedAir® 50/75i.
5.3 Starting
This chapter describes how to start the HOAF WeedAir® 50/75i after installing it.
Installation is described in chapter 3.
Everyone who works with the HOAF WeedAir®
50/75i
instructions!
5.3.1
Starting the HOAF WeedAir® 50/75i
Proceed as follows in order to start the HOAF WeedAir® 50/75i:
Carry out step 1 if the HOAF
WeedAir® 50/75i features a Clip-on
pressure controller.
1. Set the Clip-on pressure controller to
position 10. This matches 2 bar.
A pressure lower or higher than 2 bar
may damage the machine.
Version date: 2 July 2020
HOAF WeedAir® 50/75i
must
read
and
User manual
Chapter 5 - Operation
understand
these
1
Afb. 5-2: Clip-on pressure controller
5
Operation 29