Waypoints; Follow Me (Old Android App); Hard To Find Parts; Gps - WLtoys V303 Supplemental Information

Appendix 1: WLToys V303 Supplemental Information v18

Waypoints

WARNING: Do not use "Auto Make Waypoints" mode. There are reports that it corrupts internal data, and forces a
reboot of the FC. All mixing and limits need to be rechecked prior to attempting a flight.
You can set a sequence of targets and the manner (altitude & speed) in which the quad travels to each and what
happens (hovering time) at each waypoint. Be careful that the altitude of your flight clears any obstructions between
each waypoint.
So how do you get to maps when you're in the field and don't have Wi-Fi service or Telco service? First using just the
App without connecting to Wi-Fi module but connected to home Wi-Fi. Find the areas where you might want to setup
Waypoints. You have to work around the "Communication Disconnected" message ... use "locate"/"Search" then when
you have it Locate/Save Location ... for each map you want to cache.
Now when you get to your flying area and attach Android to Wi-Fi Module, you'll just need to load the correct map
(which was cached when saved).
Refer to section 12.2.7 in the GeminiAutopilotUserManual referenced earlier in this section for details.

Follow Me (Old Android App)

You can only use this if your Android device has GPS capabilities. If it does the quad will follow you and your
phone/tablet anywhere you go keeping its nose pointing towards the location of the android device.
1. I can't find the "settings" in the actual program to enable this capability. Stay-tuned

Hard to Find Parts

GPS

None of these are direct replacements and the original GPS receiver is only available with the Flight Controller ... if you
can find one.
http://www.hobbyking.com/hobbyking/s...FQeSjgod23oALw
http://www.hobbytoys77.com/zero-gpsf...3100.html#show

GPS Ceramic Patch Antenna

http://www.banggood.com/CQ65-Ceramic-Navigation-Antenna-GPS-Module-p-975091.html

Compass

http://www.hobbyking.com/hobbyking/s..._Breakout.html
Black wire is Ground "GND"
Red is power " VIN, VCC "
Pink is Roll axis "SDA"
Green is Pitch Axis "SCL"
Z axis is the altitude, lift and decent
15 June-10-2015