Modifying The Discharge Settings; Discharging The Battery - Team Orion ProSpec Advantage Instruction Manual

Modifying the discharge settings

Follow this procedure to modify the discharge settings from the main screen, use the + or -
keys to select discharge mode from the main screen (indicated by "DISCHARGE").
You can change the settings if required:
1. Press the ENTER key, the discharge current selection will blink, use the + or - keys to select a
different discharge current (0.1A to 10A, 75W maximum).
2. Press the ENTER key, the discharge cut-off voltage selection will blink, use the + or - keys to select
a different cut-off voltage. The limit is 0.7V for NiCd/NiMH, 2.8V/cell for LiPo and 2.5V/cell for LiFe.
Note: Changing the default cut-off voltage setting to a lower value can damage the battery. Only
modify this setting if you are an experienced user.
18
The charger will display the default settings for the
selected type of battery.
Team Orion Advantage Pro Spec

Discharging the battery

The charger will discharge the batteries down to cutoff value.
With LiPo and LiFe batteries, if the battery voltage is over the cutoff limit, the charger will balance
the cells (if required and balancing mode is switched on) and then discharge the battery down to the
cutoff limit. When balancing, the screen will display the „LIPO BALANCE" message.
After discharge It is recommended to recharge LiPo and LiFe batteries as they can be damaged if
stored empty.
Note: Depending on the conditions of use, the charger thermal protection might activate so that the
charger can cool down. After a brief interruption the discharge will resume and continue normally.
www.teamorion.com
After you have selected the right parameters to discharge
your battery, press and hold the ENTER key. The battery
check will be displayed.
If the battery is properly connected and functional the
discharge screen will be displayed.
19