Configuration; Opening The Housing - HMS Networks Ixxat CAN-CR200 User Manual

Configuration

5 Configuration
5.1

Opening the Housing

To operate the CAN repeater no software installation is required. The CAN repeater is configured
via DIP switches. To set the DIP switches the housing must be opened.
Fig. 1 Opening the housing
► Use a screwdriver or similar tool to press the package locks (1) down.
→ Housing is unlocked.
► Pull the front part with the board out of the housing.
Make sure, that the foil remains under the board.
►
Fig. 2 DIP switches CAN-CR200
1
CAN 2 (CAN-CR200, CAN-CR220)
2 CAN 1
3 S301
4 S302
5
CAN 3 (CAN-CR200, CAN-CR210/FO)
The DIP switches of CAN-CR210/FO and CAN-CR220 are approximately at the same positions.
CAN Repeater User Manual
1
1
2
1
5
3 4
4.01.0067.20000 3.4 en-US
7 (22)