Table of Contents
Advertisement
Technical Data
9
Technical Data
Weight
Operating temperature
Storage temperature
Power supply
Housing material
CAN transceiver
Max. number of bus nodes
CAN bus termination resistor
CAN bit rate
Protection class
Relative humidity
CAN-CR200
Dimensions
Current consumption at 24 V
Galvanic isolation
CAN propagation delay (typical)
CAN-CR220
Dimensions
Current consumption at 24 V
Galvanic isolation
CAN propagation delay (typical)
CAN-CR210/FO
Dimensions
Current consumption at 24 V
Galvanic isolation
CAN propagation delay (typical)
FO transmitter
FO receiver
FO connector
FO line
Maximal line length between two
FO repeaters
CAN Repeater User Manual
Approx. 300 g
-20 °C to +70 °C
-40 °C to + 85 °C
+9 V to +32 V DC
Polyamid
Texas Instruments SN65HVD251
120
120 Ohm switchable via DIP switch
1 Mbit/s
IP30
10 to 95 %, non-condensing
22.5 x 100 x 118 mm
Typ. 41 mA, max. 100 mA
1 kV DC/1 sec, 500 V AC/1 min
CAN 1, CAN 2 and backbone bus galvanically isolated against each other
Typ. 200 ns (40 m bus length)
22.5 x 100 x 118 mm
Typ. 41 mA, max. 100 mA
CAN 1, CAN 2 and power supply galvanically isolated against each other
1.01.0067.44400: 2 kV AC/1 min, 3.5 kV AC/1 sec, 3.2 kV DC/1 min, 4 kV DC/1 sec
1.01.0067.44300: 3.75 kV AC/1 min, 4 kV AC/1 sec, 4 kV DC/1 min, 4 kV DC/1 sec
Typ. 175 ns (35 m bus length)
22.5 x 100 x 120 mm
Typ. 62 mA, max. 100 mA
1 kV DC/1 sec, CAN 1 500 V AC/1 min
Typ. 300 ns (60 m bus length) between wire connection of a FO Repeater through
the fiber optic cable to the wire connection of a second FO Repeater (not including
the signal delay time of the fiber optics: approx. 5 ns/m)
Broadcom HFBR 1404Z, 820 nm
Broadcom HFBR 2402Z, 820 nm
F-SMA or ST connector
Multi mode fiber optic cables (only glass);
Recommended: 50/125 μm, 62.5/125 μm,
also compatible with: 100/140 μm, 200 μm (consider max. line length)
50/125 μm: 1500 m
62.5/125 μm: 2000 m
16 (22)
4.01.0067.20000 3.4 en-US
Advertisement
Table of Contents
