Installation
6
Installation
6.1
Mounting the Device
Before mounting the device, make sure the following settings are configured:
•
bus termination (see
•
bit rate (see
•
lock time (see
6.1.1
Mounting a Single Device
Fig. 3
Mounting on DIN rail
►
Make sure, that the device is not connected to power supply.
►
Hook the device onto the upper lip of the rail and push downwards (1).
Push the device towards the rail until it snaps into place (2).
►
6.1.2
Connecting Several Devices
CAN-CR200 and CAN-CR210/FO support a DIN rail bus extension. With this the device can be
connected to other CAN-CR200 devices or CAN-CR210/FO devices. It is possible to realize a star
topology with up to 240 CAN connections.
CAN Repeater User Manual
Configuring the Bus Termination Resistors, p.
Configuring the Bit Rate, p.
Configuring the Lock Time, p.
1
Allocation of the DIN rail bus extension is HMS specific!
Other than HMS devices may be damaged.
Connect only HMS devices to the HMS TBUS plug.
8)
9)
2
10 (22)
8)
4.01.0067.20000 3.4 en-US