Storage; Troubleshooting - Silvercrest SKV 1200 B2 Operating Instructions Manual

■ Now you can clean all the parts (blender jug C,
blade holder A the blade z and sealing ring B)
in warm water with a little washing up liquid
using a washing up brush . Afterwards, rinse all
the parts with clean water so that no detergent
residues remain .
NOtE
► The blender jug C and the measuring cup e
are dishwasher-safe .
If you clean components in the dishwasher,
please ensure that no plastic parts can get
jammed or caught anywhere . This may cause
them to become deformed . We recommend
using the top rack of the dishwasher and a
washing programme with max . 45°C .
■ After cleaning, reassemble the blender:
–
Push the sealing ring B back into the recess
on the blade holder A with the blade z .
–
Place the blade holder A with the blade z
back into the blender jug C so that the
blade z protrudes into the blender jug C .
Note the corresponding slots on the blender
jug C .
–
Turn the blade holder A clockwise as far
as possible so that the blade holder A sits
firmly on the blender jug C again .
–
Press the blender lid r with the measuring
cup e slightly offset firmly back onto the
blender t . Close the blender lid r by
turning it clockwise as far as the stop back
into the catch on the blender t . Ensure
that the pouring spout on the blender t is
closed .
■ 26 │ GB │ IE
In most cases, you can achieve sufficiently hygienic
cleaning of the blender t immediately after use in
the following way:
1) Put some water containing a little detergent
into the fully assembled blender t .
2) Press the blender lid r with the measuring cup e
slightly offset firmly onto the blender t .
Close the blender lid r by turning it clockwise
as far as the stop back into the catch on the
blender t . Ensure that the pouring spout on
the blender t is closed .
3) Switch on the blender t for a few seconds .
4) Pour out the washing water . Any residues can
be removed with a washing-up brush .
5) Then rinse out the blender t with plenty of
clean water so that all detergent residues are
removed .

Storage

■ Store the cleaned appliance in a clean, dust-free
and dry location .

Troubleshooting

If the appliance suddenly stops working:
■ The appliance has overheated and triggered the
automatic safety cut-out .
–
Turn the rotary switch 3 to 0 .
–
Remove the plug from the wall socket .
–
Allow the appliance to cool for 15 minutes .
–
If the appliance has not yet cooled off com-
pletely after 15 minutes, it will not start .
–
Wait a further 15 minutes and try switching
on again .
If the appliance cannot be switched on:
–
Check that the plug is correctly connected
to a wall socket .
–
Check whether the swivel arm 1 is in the
wcorrect position .
SKV 1200 B2