Maintenance - Husqvarna T540i XP Operator's Manual

• Make sure that you are stable on your feet and
keep a low lateral force when you cut vertical
branches. Steer the safety line through a different
connection point to remove or prevent increasing
lateral forces. You can also use an adjustable strop
directly from the harness to a different connection
point.
• Use a foot loop to keep a safe work position.
• Do a check of the harness, belt and ropes at a
regular interval.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
WARNING:
before you do maintenance.
18

Maintenance

Read and understand the
Remove the battery
• If you must climb with the product, attach the
product to the rear connection point on the
harness. The rear connection point keeps the
product clear from climbing lines and makes sure
that the weight has central support down your
spine.
WARNING:
chain brake when you lower the product
onto its strop.
To remove a trapped product
1. Stop the product.
2. Attach the product safely to the tree inboard,
against the trunk side, of the cut or a different tool
line.
3. Carefully pull the saw away from the kerf while you
lift the branch as necessary.
WARNING:
product free. Risk of serious injury.
4. If it is necessary, use a hand saw or a second
chainsaw to release the product. Cut the branch at
a minimum of 30 cm/12 in from the caught product.
Make the cut on the outer end from where the
product is caught.
The following is a list of the maintenance steps that
you must do on the product. See
18 for more information.
You must engage the
Do not try to pull the
Maintenance on page
1036 - 005 - 29.06.2020