Assembly - Husqvarna T540i XP Operator's Manual

To assemble the guide bar and saw
chain
WARNING:
before you assemble or do maintenance on
the product.
1. Disengage the chain brake.
2. Loosen the bar nut. Remove the drive sprocket
cover and the transportation ring (A).
3. Install the guide bar on the bar bolt.
12

Assembly

Always remove the battery
A
4. Steer the guide bar to its most rear position. Lift the
saw chain above the drive sprocket and engage it
in the groove on the guide bar. Start on the top
edge of the guide bar.
5. Make sure that the edges of the cutters point
forward on the top edge of the guide bar.
6. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
7. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
8. Make sure that the saw chain is correctly engaged
in the groove in the guide bar.
9. Tighten the bar nut with your fingers.
10. Tighten the saw chain. Refer to
tension of the saw chain on page 24 for
instructions.
To install the air intake cover (optional)
If you cut materials that cause much dust and small
particles in the air, a air intake cover is recommended
for use.
1. Hold the air intake cover against the fan housing.
Make sure to put the hole in the air intake cover on
the right side of the hole in the fan housing.
2. Carefully push the air intake cover against the fan
housing until you hear a click.
To adjust the
CLICK!
1036 - 005 - 29.06.2020