Setup / Basic Operation; Remote Control - it ITVS-760B Instruction Manual

Wooden music center with bluetooth and recordable cd player/usb

Hide thumbs

Table Of Contents

Table of Contents

Setup

1. Remove white protective needle cover by gently pulling towards front of unit.

2. Remove any packaging materials from the unit.

3. Connect the AC power cord

to a wall outlet.

Note: To prevent interference, avoid bundling audio signal cables together with the AC power cord.

Basic Operation

1. Press the POWER button to turn the unit on.

2. Select the source by pressing the corresponding mode

button

(AUX/Bluetooth / PHONO / AM/FM / CD/USB / TAPE)

Please note: Push the source and it will light up showing that you

have selected it. These are the only 5 buttons that will light up.

3. Rotate the VOLUME knob to adjust to the desired sound level.

The volume reading is "00-32" the volume will change along with the number.

Listening through Earphones/Headphones (not included)

For private listening, first reduce the volume level to minimum.

Insert your headphones' plug into the

adjust the volume up by turning the VOLUME knob.

Note: The speakers will automatically be deactivated while

headphones are plugged in.

CONDENSATION WARNING:

When the unit is moved from a cold or warm place, or is used following a sudden temperature change, there is the

danger that water vapor in the air may condense on the unit, preventing proper operation. In such cases, leave

the unit for 1-2 hours after plugging it into an AC outlet to allow it to stabilize at the temperature of its surroundings.

When using the remote control, point it towards the remote sensor on the front panel of the unit.

Notes:

- Even if the remote control is operated within the effective range, remote control operation may be

impossible if there are any obstacles between the unit and the remote control.

- If the remote control unit is operated near other devices which generate infrared rays, it may not

function properly. Conversely, the other devices may not function incorrectly.

Battery Installation

Remove the battery compartment cover.

Insert 2x "AAA" batteries.

Note: Make sure that they are oriented so their polarity

markings, "+" and "-" match the remote's markings.