Specifications - it ITVS-760B Instruction Manual

•
To keep the laser pickup clean, do not touch it, and do not forget to close the disc tray.
•
Do not attempt to clean the unit with chemical solvents as this might damage the finish.
•
For cleaning, only use a clean, dry cloth.
•
In order to shut off the power to this product completely, unplug the power cord from the
wall outlet. Be sure to unplug the unit if you will not intend to use it for an extended period
of time.
How to Replace the Turntable Stylus
The stylus should last about 50 hours under normal use. However, it is recommenced that the stylus
be replaced as soon as you notice a change in sound quality. Prolonged use of a worn-out stylus
may damage the record. The highest speed of 78 RPM records will wear out the stylus faster.
Removing the old stylus:
1. Set a screwdriver at the tip of the stylus and push downward (A).
2. Remove the stylus by pulling it downward and forward simultaneously.
Installing a new stylus:
1. Hold the front tip of the stylus and insert its rear edge (B) first.
2. Push the stylus upwards (C) until the tip locks into place.
Caution:
Do not remove or bend the stylus.
Do not touch the needle to avoid injury your hand.
Turn off the unit's power before you replace the stylus.
Keep out of reach of children.
GENERAL
Power Requirements
Power Consumption
Dimensions (W x H x D)
Weight
AMPLIFIER
Output Power
Frequency Response
SPEAKER SYSTEM
Type
Impedance
Input Power
FM Radio
Range
AM Radio
Range
CD PLAYER
Frequency Response
Signal-to-Noise Ratio
CASSETTE PLAYER
Track System
Tape Speed
Wow and Flutter
Frequency Response
RECORD PLAYER
Motor

Specifications

AC 120 V~ 60 Hz
42W
460mm x 243mm x 335mm / 18.11in x 9.5in x 13.2in (approx.)
8.6 kg
. / 18.96 lbs (approx.)
5 W + 5 W
60 to 20, 000 Hz
1-way
12 ohms
Max. 10W
88 to 108 MHz
530 to 1710 KHz
60 to 20, 000 Hz +/-4 dB
55 dB (IEC-A)
4 Track, 2 channel stereo
4.8 cm/sec
0.4% (WRMS)
125 to 6300 Hz +/-6 dB
DC servo motor
22