Table of Contents
Advertisement
Drive System
Speeds
S/N Ratio
Cartridge Type
Stylus
BLUETOOTH
Bluetooth Version
Bluetooth Profiles
Bluetooth Frequency range
Operating Distance
Symptom
Unit will not power on.
•
No sound output from
•
speakers.
Noise/Distortion in
•
sound output.
Unit fails to respond.
•
The tape does not play.
•
Cannot listen to any
•
station, or signal
appears weak.
The sound is distorted.
•
CD stops immediately
•
after starting, or unit
pauses or stops during
play.
No sound.
•
CD playback is noisy, or
•
playback stops or skips.
CD tray will not open.
•
Buttons are not
•
functioning correctly.
Belt Drive
33-1/3 rpm, 45 rpm and 78 rpm
More than 50 dB
Ceramic Stereo Cartridge
ITRRS-300
Bluetooth V2.1 + EDR
A2DP, AVRCP
2.402GHz-2.480GHz
10 meters (33 ft.)
Troubleshooting Guide
Possible Cause
Unit is unplugged.
•
The volume level is set too low.
•
The input selector does not
•
match the playback source.
The unit is too close to a TV set
•
or another interfering device.
It might result from external
•
factors such as ESD
(Electro-static discharge).
The cassette tape is not
•
inserted properly.
The tape has reached the end.
•
The station is not tuned-in
•
properly.
A TV set is being used nearby
•
and is interfering with the radio
reception.
The antenna is not oriented
•
properly.
The CD is inserted upside
•
down.
The CD is dusty or dirty or there
•
is condensation on the CD.
The CD player is paused.
•
The CD is scratched, damaged
•
or warped.
The disc is very dirty.
•
AM/FM mode is selected.
•
The unit is processing
•
information ("--- Busy" is
displayed)
The unit needs to be restarted
•
23
Solution
Connect the unit to the AC
•
power supply.
Adjust the volume.
•
Select the correct input
•
source.
Turn off the TV or other
•
appliance, and relocate
the unit.
Disconnect the power cord
•
and external audio
device. Re-plug the power
cord after one minute.
Insert the cassette tape
•
correctly.
Flip the cassette.
•
Properly tune-in the
•
desired station.
Turn-off the interfering TV
•
set.
Re-orient the antenna until
•
reception improves.
Insert the CD with the
•
printed side right-side up.
Carefully clean and dry the
•
CD.
Press the PLAY/PAUSE
•
button.
Replace CD with an
•
undamaged one.
Carefully clean the CD.
•
Select AUX, PHONO, CD,
•
or TAPE mode.
Wait until the unit finishes
•
processing.
Turn the unit off, then on
•
again.
Hide quick links:
Advertisement
Table of Contents
