Advertisement
6.0 OPERATING THE CONTROL PANEL
1. BEFORE COOKING
The LED flashes 3 times when plugged in power supply.Then it flashes ":", prompting you to input the cooking menu and time.
2. AUTO COOKING/TIME.WEIGHT BUTTON
You can increase or decrease cooking time, weight or set auto cooking menu during operation by pressing Auto Cooking/
Time.Weight button.
3. STOP/CLEAR
At the initial or input stage: press once to cancel input programs and resume initial stage.
During cooking: press once to stop oven operation, press twice to cancel cooking programs.
4. AUTO REMINDER
When your preset cooking procedure have finished, the LED Display will show End and three beeps sound will be heard to
prompt you to take out food. If you do not press Stop/Clear button once or open the door, the beep will be sounded at an
interval of 3 minutes.
5. CLOCK SETTING
Clock button make it available for you to input current or preset time.When ":" flashes onto LED display after plugged in, or
try to skip it over to continue if unnecessary.
Steps
After power-up, the colon flashes
1
Press Preset. Clock button once
2
Press Auto Cooking/Time Weight button to set exact hours.
3
Press Preset. Clock button once again.
4
Press Auto Cooking /Time Weight button to set exact minutes.
5
Press Preset. Clock button once again or wait for 5 seconds, and the numbers will go steadily.
6
Figure 9
Example: to set 12:30
9
GB IE
Display
:
0:00
12:00
12:00
12:30
©
2019 Focal Point Fires plc.
Advertisement
