Twin-Star International DFI-5010-01 Manual

MODELS: DFI-5010-01, DFI-5010-02, DFI-5010-03,DFI-5010-04,DFI-5010-05,DFI-5010-06
Go to www.tsicustomerservice.com for product warranty registration
ASSEMBLY INSTRUCTIONS
1
Leg
Bracket
MOUNTING THE LEGS
1. Align the mounting tab into the bracket and lower the leg into
place. (Fig 1)
2. Fasten the leg to the bracket using the included screws, 3 per
leg.
OPERATING INSTRUCTIONS
PRODUCT SPECIFICATIONS
VOLTAGE
AMPS
WATTS
Distributed by
Twin-Star International, Inc. Under license.
duraflame™ and the duraflame flame
logo are trademarks of Duraflame, Inc.
2
Remote Receiver
Control Panel Location
Control Panel
120 VAC, 60 Hz
12.5 Amps
1500 Watts
Twin-Star International, Inc.
Delray Beach, FL 33445
Made in China • Printed in China
OPERATING INSTRUCTIONS
The POWER button supplies power to all the
functions of the heater. Pressing the POWER
button again the heater will be put in standby
mode. This will turn off all functions at once but
will hold the settings in the memory. By pressing
the Power button again the unit will turn on at
the same settings.
With the power on press and hold the Power
button on the control panel for 10 seconds to dis-
able or re-enable the heater function. Once
disable or re-enabled the emberbed lights will
flash multiple times.
There are 5 brightness levels that can be selected
and OFF (00) setting.
Settings F5 - F1 decrease in brightness.
The stove contains a fan forced infrared element
heater.
The thermostat setting range is 62°F - 82°F (17°C
- 27°C) or continously ON or OFF(00).
The thermostat is adjustable by 2°F or 1°C
increments by pressing the HEATER button on the
control panel.
To change between °F and °C press and hold
the HEATER button on the control panel for 3
seconds.
The button on the remote only turns the heater
on/off to the thermostat setting selected with the
control panel.
Pressing the timer button will cycle through the
timer settings; 30 minutes, 1 Hour, 2H, 3H, 4H,
5H, 6H, 7H, 8H, 9H and off (00).
Remote Control
www.tsicustomerservice.com
Note: When first running the heater there can
be an odor. This is normal, the heater has a
surface coating on the internal parts, for the
first several hours of operation the coating
reacts with the internal parts to permanently
protect them. The odor is safe; if you are
sensitive to the odor it is recommended
to run the heater in a well-ventilated area until
the odor dissipates.
Warning: This is an unvented, electric
appliance. DO NOT attempt to burn wood or
manufactured firelogs in or on this appliance
or grate.
-- POWER
-- FLAME
-- HEATER
-- TIMER
For Customer Service:
(+1) 888-674-7517
8:30 a.m.-5:30 p.m., EST, Monday-Friday
© 2016,Twin-Star International,Inc.
Made in China
Printed in China