Step 7 Cable #1 - Vision Fitness Multi-Station Gym ST710 Owner's Manual

CABLE #1
7
STEP
Thread the bolt on the end of the cable (the
end with the permanent bolt affixed) to the
header plate a minimum of 1", after slipping
the closed loop of the weight selector pin
tether over the attached nuts. Remove the
slotted bolt and nut from the opposite end of
the cable. Route the cable through the
A
following pulleys in the order specified:
B
Over pulley A, under B, over C, over D,
over E, over F, under G, and thread a minimum
C
of 0.5" into floating pulley housing H (after
D
reattaching the slotted bolt and nut). Tighten
the nut against the pulley housing.
E
WARNING: Failure to thread the ends in
t h e s p e c i f i e d d i s t a n c e c a n r e s u l t i n
F
serious injur y!
H
G
17