Page 4
IC: 12409A-DW099S Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may The DW099E and DW099S tools emit a visible laser not cause interference, and (2) this device must accept beam, as shown in Figure #1.
Page 5
Under Industry Canada regulations, the radio transmitter(s) When the tool is ON, the battery level appears in the in this device may only operate using an antenna of a type display window (Figure #1). and maximum (or lesser) gain approved for the transmitter Operation by Industry Canada.
Page 6
Measuring Area Measure the width. You can measure the area of a wall, floor, or object. • Point the top of the tool at one side of the target (room or object). Click (Figure #5) to turn on the tool. •...
Page 7
“THE BLUETOOTH ® WORD MARK AND LOGOS ARE REGIS- TERED TRADEMARKS OWNED BY BLUETOOTH SIG, INC. AND ANY USE OF SUCH MARKS BY DEWALT INDUSTRIAL TOOL CO. IS UNDER LICENSE. OTHER TRADEMARKS AND TRADE NAMES ARE THOSE OF THEIR RESPECTIVE OWNERS.”...
Page 8
90 DAY MONEY BACK GUARANTEE If you are not completely satisfied with the performance of your DeWALT Power Tool, Laser, or Nailer for any reason, you can return it within 90 days from the date of purchase with a receipt for a full refund - no questions asked.
Page 9
Error Codes If INFO appears on the display window with a Code number, perform the corresponding Corrective Action. Code Description Corrective Action Received Signal Too Weak, Use the target plate or change the target surface. Measuring Time Too Long Received Signal Too High Target is too reflective.
Page 10
Specifications Range 4in to 100ft (.1m to 30m) Measuring Accuracy* ± 3/32in (± 2mm)* Resolution** 1/16in (1mm)** Laser Class Class 2 (IEC/EN60825-1: 2014) Laser Type ≤ 1.0mW @ 620-690nm Laser/Backlight Automatic Switch-off After 30s Unit Automatic Switch-off After 90s Continuous Measuring Area/Volume Battery Life (2 x AAA) Up to 3000 Measurements (2500 with...